Pet Safe Wireless Collar Not Working

Take the collar to the boundary area of your containment system and listen for the collar to beep.

Pet safe wireless collar not working. Chances are your dog hears it just fine. Stay play wireless fence receiver collar pif00 12918 pif00 14288 stubborn dog stay play wireless fence rechargeable. The petsafe collar is not working troubleshooting tips now that you have opted for one of the petsafe collars there are a few tips you need to keep in mind before you begin using it. Remove the collar from your pet.

Remove your pet s receiver collar from your pet. Take the receiver collar use the test light tool or listening to the collar for the beeping. If you wish to test the battery. If this light is flashing replace the battery.

The base unit sits in your house and the battery operated collar reacts when your pet approaches the boundary zone. Make sure the static correction level on the receiver collar is set at 2 or above. This does not indicate that your collar is not working only that you do not hear it. If your receiver collar is not beeping or correcting your dog.

Troubleshooting your petsafe radio fence includes testing each of its components including the collar the boundary width the transmitter the underground wires and other electrical fixtures that can cause interference with your system. If receiver collar still does not activate remove a wire from the transmitter try to change the levels. Take the test light tool and place it on the receiver collar and walk out to the boundary of the containment system. This is not a fool proof evidence that the fence is not working.

As you walk away from the transmitter and approach the boundary the test light illuminates or you ll hear the collar beep at the boundary. Work with these collars. Will a wired receiver collar work on a wireless system. The wireless pet containment system uses a radio signal to keep your pet in an area up to 1 2 acres.

We have gotten calls that the collar is not working because the dog is not crying or whimpering when he gets too near the fence. If this happens the system is working. The collar has a low battery indicator light which will flash 4 5 seconds when your battery is low. If everything appears to work normally please contact our customer care center to discuss replacing transmitter.

Unfortunately a wired receiver will not work with a wireless system nor will a wireless receiver collar work with a wired system. If receiver collar does activate the boundary wire probably has a partial wire break. If the test light flashes your collar is working and you should try check the following.