Petsafe Wireless Collar Not Working

Rechargeable collars typically take about 14 to 16 hours to charge and will remain usable for 1 to 2 months depending on how frequently you use them.

Petsafe wireless collar not working. Make sure you touch both points on the receiver at the same time when you hear the collar beeping. It is a good idea to check the battery monthly until you know roughly how often you need to replace it based on your pet s behavior. If the collar beeps or the test light tool illuminates the battery and collar are working. If not replace the battery.

If not there are two feasible options. Test the collar and hold it about a foot from the wire. If receiver collar still does not activate remove a wire from the transmitter try to change the levels. Check the fit of the receiver collar on your pet.

Discharge all power by holding the correction level button down until the led is no longer illuminated. If you do not feel a shock then there may be a problem with the receiver collar. Touch both points on the collar while it is ticking or beeping. Use the warranty and change the collar or use a more shocking level of vibration electric shock.

To replace the battery use a coin or the flat side of the test light tool. If they do not replace the battery in the collar. Remove the receiver collar from your pet. Take the test light tool and place it on the receiver collar and walk out to the boundary of the containment system.

It will tell you definitively that the fence is or is not working. If the collar beeps and the transmitter is working the problem is a break in the boundary line that needs splicing. If you have a containment system the transmitter may be failing to send a signal or your wire may be nicked or broken. The base unit sits in your house and the battery operated collar reacts when your pet approaches the boundary zone.

There are various reasons your collar may not be working including a malfunction of the collar or a battery outage. If the test light flashes your collar is working and you should try check the following. The solution of the most common problems in petsafe fences petsafe collar beeping but not shocking. The wireless pet containment system uses a radio signal to keep your pet in an area up to 1 2 acres.

It should beep and the test light should flash. It is best to check that the batteries and configuration work properly. If everything appears to work normally please contact our customer care center to discuss replacing transmitter. If receiver collar does activate the boundary wire probably has a partial wire break.

Your petsafe collar could be either rechargeable or battery operated so the first thing you need to do is check whether it is charged or if the batteries are working.